DIRECTIONS FOR USE AND DOSAGE: Adjust the pH of the water between 7.2 and 7.6. Dissolve the recommended doses of this product in 1 or 2 liters of water to distribute it better in the pool water. Do not mix it with other chemical products. Perform the treatment preferably dusk, with the pool out of use. Initial treatment: 3 tablespoons large rasas (30 / 35gr) every 1000 L. Maintenance: Daily a small spoonful rasa (6 / 7gr) every 1000 liters. Free chlorine 0.5-1.5mg / l.

DOSIFICACION Y MODO DE EMPLEO:Cortar las marcas circulares( ambos lados) existentes desde 10 a 30 m3 en fracciones de 10m3 según el volumen de la piscina.<10m3= 1 agujero/ 10 - 20 m3=2 agujeros/20-30m3=3 agujeros. Colocar el recipiente dentro del agua, quedando boca abajo, sosteniendolo verticalmente hasta que se haya introducido suficientemente agua en el interior del envase para que la linea de flotación del envase sea 3/4 del envase y dejar flotar.

THE ANTIGRAPAL OF YOUR POOL. Solves the problem of green or turbid water in a minimum amount of time. Acts quickly against contamination 8 algae, bacteria, fungi, etc). Turning the water to its perfect state. DOSE: Add 500gr (one container) per 25 m3 of water.

DOSIS DE USO: Tratamiento inicial: Añadir 15g por cada m3 de agua. Transcurridas 2h, ajustar el pH del agua entre 7,2 y 7,6. Tratamiento de mantenimiento: Con el pH del agua ajustado, añadir a diario de 1 a 3 gr. por cada m3 de agua.

METHOD OF USE: Initial or shock treatment: 1L of NON-FOAMING ALGICIDE for each 100m3 of water. Maintenance treatment: 0.5L of NON-SPARING ALGICIDE for every 100m3 of water every 7 days. All doses are indicative.

DOSES OF USE. Initial or shock treatment: Add 15gr of CHLORO CHLORO for each cubic meter of water. After 2 hours, adjust the pH of the water between 7.2 and 7.6, using INCREMENTER or pH REDUCER. Maintenance: With adjusted pH, maintenance can be done in two ways. A: add in the skimmer baskets 1 compact for every 15m3 of water, weekly. B: In installations with dispenser, fill it with compacts and then circulate the water. All doses are indicative.

HOW TO USE. Recovery treatment: with the filtration equipment stopped and without the presence of bathers in the pool add 250 to 1500ml of LIQUID FLOCCULANT for each 100m3 of water depending on the turbidity of the water. Pour the necessary dose in a container with water and distribute this solution, on the surface of the pool by the same. After about 8 hours, the floc layer of the bottom of the pool will be collected and removed.

DIRECTIONS FOR USE: The pH of the pools should be between 7.2 and 7.6. When it is higher than 7,6 1.5 kg of product, previously dissolved in water, per 100 m3 of water and for every 2 tenths of pH to be reduced will be added.

False